If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I like the general idea itself, but the execution is a bit lacking imho. Pulling off 16s on the E36 is not easy - on the Touring it's incredibly hard. To date, the only sets of 16s I've seen on E36s that really looked good... well, they were wide with lots of dish and silly offsets. Something around 9x16 front and 10x16 rear is needed to pull off 16s.
Maybe, just maybe the small widths could work too if the car was even lower.
That said, I'm not really a fan.
/edit:
I just noticed the exhaust.
318td? 325td? Or a 325tds? Props for modding a Diesel Touring. Not many people would do that, gets my thumbs up.
Sinces theres zero info, im guessing 16"s? Somhow it looks a little too small on that car.. I have seen many e36's with 16s pulling it off, but this time i dont think it suits the car.. Maybe spacers would sort that out?
But other wise, from what i actually can see, it looks decent and low.
Leave a comment: