bbs rs on e30

[D-rock]

I just got these today and test fit them. They are a bit wide... IDK petty upset what do you guys think?

[ECKS///M3]

Too wide? Nah, perfect! Get it dun.

[Stephen]

sell them to me?

Seriously though. If you dial in some negative camber for the fronts ( its hard to tell when its on the lift) thatll bring em in closer.

[Bimmerteck]

Is your car already 5 lug swapped? If not the width of an adaptor will likely put them too far out there.

[c-ron]

With the car down they should fit just fine

[D-rock]

I still havnt rolled or pulled my fender. Im think it might be to wide ;( But i trust you guys

Yah its 5x120 swap

[Oscar]

They look good. What are the specs?

[Tuck&Poke]

you cant tell with it on a lift, set it down on some blocks of wood and see how it sits then.

[Bimmerteck]

With some decent camber plates you should be good to roll then.

[D-rock]

They look good. What are the specs?

BBS RS 16 x 8 ET 20mm
BBS RS 16 x 9 ET 24mm

[Oscar]

Yeah they'll fit with rolled fenders and a little negative camber.

[D-rock]

But also i have e36 conversion. So it has to be e36 offset. I have to go back to the shop.

[TheNeek]

I'm with everyone else. Load up the suspension before you start panicking. I panicked about the rears on the E21 when it was up in the air, but they just nestled right in there.

[D-rock]

Thanks guys! Will hopefully update tom.!

[TheNeek]

From my build. I was a skeerd when I saw this:





But it all worked out in the end.