Sawblades (not VW content)

[capiton23]

98 stratus block, srt internals. will be boosted when funds permit. along with moar low. lol. i **** being broke..

check out here for a stanced 1st gen. he has somewhat of the same suspension, as thats the only way to get that low it seems

[vdubLalo]

^^^ sick neon lol is the 2.4 out of a stratus? our buddy had a few of those.... And no skid plates

Thats not sick

[dailydraggd]

snowed here in pa

[dailydraggd]

no skid plates haha. ive already ripped my gas tank off twice and put a few holes in it. thank god its plastic. its damn near impossible to wack oilpan or trans so thats all good. only thing i worry about are my gas and brake lines there all banged up already i might run them inside the car but like i said id rather do that on the new project

[JasperThomas]

I like it even more now seeing some shots from further back. Sitting DAMN low.

[Byron]

I don't believe the half inch claim.

[dailydraggd]

my buddy said the motor mounts a half inch its really one inch. i can get pics up if your gonna doubt ha

[capiton23]

this makes me want to go ahead and re-do my suspension. thanks for the motivation xD

[standard125r]

Dig the look...Thanks for the side shots.

[FittedDownLow]

I don't believe the half inch claim.

ok well you can see the pinch weld under the car is lower then the bottom sidewall of the tire and its a 35 series but since you dont believe me heres a picture.......



^^^ thats taken with my camera setting on the ground and thats just body.... let alone what hangs under the car

[FittedDownLow]

I made a diagram for the non believers......

[alexdc5]

i really like it. if the front could sit at the same height as the rear, it would be sick

[bigtoepfer]

wow,

I dislike sawblades, and neons.


That said this is only the 3rd car I've seen with the vette wheels that I like that wasn't a vette. Well done sir. And congrats on getting the forum in such an uproar. Your AOK in my book haha.

[stanced?]

gud job man i luv it keep it coming

[stanced?]

all it needs is a front lip or a lower bumper...