2010 Dodge Charger Wide body Build

[Ramrod]

Might be a bad angle but that front flare looks like its mounted pretty low

It's with in 1/4in where it should be.

[xxcody2130xx]

Might be a bad angle but that front flare looks like its mounted pretty low

[Ramrod]

Wide Body Flares came in today. Real quick mock up.



Fronts measured just over 2.5in wider then the factory fenders.




The Rears were about 1in Wider then fronts. Which is what I wanted.

[Ramrod]

Stuff should be here on Monday. Didn't do much to my car, but did work on a showboard for another Mopar guy.

[mrmomoz]

following, keen to see it all on the car!!

[Ramrod]

Bumper, Wickerbill and Wide Body Flares are Finished.

This Bumper is just sick...

[Ramrod]

Fog Lights opened up and cleaned. Some sanding and edge work done. Starting to get the finished look.

[Ramrod]

this is rad, can't wait to see how this turns out. Side note, is this a hemi or v6?

v6 right now. After SEMA, we are working on the power plant. On the fence if a HEMI will go in or a Built LS 6.0L.

[slamitall]

this is rad, can't wait to see how this turns out. Side note, is this a hemi or v6?

[Ramrod]

Grill mesh is all fitted and installed

[Ramrod]

Got a chance to go by AAD Performance today and check out the shop. Watched a couple of Jeep Arms be made and had a chance to see their Front upper and Rear Control Arms. They had another brand there and some stockers to compare theirs too. You could easily see how much better AAD arms are then others.

[Ramrod]

[Ramrod]

[Ramrod]

[Ramrod]