Raising Junior: A video build

[A4crn]

Here's some bonus pictures of the inner rear wheel arch

Welcome to the bat cave :O



Chassis edge repaired



Repaired the flap



Tacked in



Welded and ground welds with a coat of primer



I still need to add the bumpstop mount to finish this part

This was what was left of the bumpstop mount, it came off and was stuck to the axle:



I had to trim the new part as it was for a later model, but the main section is the same as for an earlier car:





To this...welds turned out pretty good too, just need to go over the bottom weld again

[A4crn]

Episode 3 is now online

[Session]

Just finished episode 2. Did you actually machine 2 pieces just for that recess? Isn't that costly and time consuming?

[A4crn]

Not when you have a milling machine at work that you can use after hours

[A4crn]

Hey guys, Episode 4 is up,

[A4crn]

Episode 5 of the build:

[A4crn]

Episode 6 is up

[A4crn]