Announcement

Collapse
No announcement yet.

Champagne Realities RX7

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dome
    replied
    Crazy project dude, can't wait for more

    Leave a comment:


  • white out
    replied
    Love the powertrain build.


    Going to put this out there. Keep the stock body.

    Leave a comment:


  • danny33
    replied
    .
    Last edited by danny33; 04-07-2018, 03:57 PM.

    Leave a comment:


  • danny33
    replied
    .
    Last edited by danny33; 04-07-2018, 03:57 PM.

    Leave a comment:


  • danny33
    replied
    Finished up my fuel system plumbing. I have to mount the bulkhead fitting to the sender cover and install the fuel pump and that can get checked off the list.

    feed line plumbed up


    return line




    had to do alittle massaging to fit that big ass 90* -8

    and all set. the return from the FPR is ran to the stock feed hardline back to the tank.


    then subframe went back in and i threw everything on for a couple progress pics






    engine came out again to finish up the bay and get started on the chassis harness. threw in a new master cylinder because the stock one was leaking and then bent up a new passenger line which is much neater than the stock one.

    Leave a comment:


  • danny33
    replied
    .
    Last edited by danny33; 04-07-2018, 03:57 PM.

    Leave a comment:


  • Paradi$e
    replied
    me likey a lot

    Leave a comment:


  • danny33
    replied
    .
    Last edited by danny33; 04-07-2018, 03:56 PM.

    Leave a comment:


  • scweet14
    replied
    ohhh fuck this is sooooo good!

    Leave a comment:


  • Skervey
    replied
    Killer pic and killer project!

    Leave a comment:


  • danny33
    replied
    .
    Last edited by danny33; 04-07-2018, 03:56 PM.

    Leave a comment:


  • danny33
    replied
    got my flywheel and adapter plate in from collins performance this week. very high quality and fit was perfect on the adapter plate!





    all the plate to engine bolts are provided and the trans to plate bolts can be found at any hardware store.


    bolted to the engine






    tight squeeze, this would not have been possible without a load leveler


    shes in! the transmission clears the side of the tunnel with minimal massaging. Currently the engine is farther forward and not pitched correctly as the back top of the trans (right after the black cover) is sitting on the top of the tunnel. the seam in the engine bay also needs to be notched. When i pull it back out i have to do more massaging or might open it up alittle.


    gonna order my single turbo manifold this week and pickup my clutch and some maintenance items for the engine before i put it back in for the final time

    Leave a comment:


  • danny33
    replied
    .
    Last edited by danny33; 04-07-2018, 03:56 PM.

    Leave a comment:


  • Tate
    replied
    2j All the things. Looking really good.

    Leave a comment:


  • White325is
    replied
    Nice build so far, looking forward to the swap.
    Are you going to school in Williamsport?

    Leave a comment:

Working...
X