If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
This is on only 1 cut coil and this was taken about 4 weeks ago, I've now cut 3 in the front total and the back I have yet to get to. Im saving up for a set of raceland e36 fronts, 500sl springs cut with ranger struts in the rear. Making my own DIY arms in the rear as well and I'm going to fabricate some camber plates for the front. I had a set of RS90's that I was going to pick up but the guy was sketchy as hell and they needed major refinishing and the lips had a lot of rash...So im just going to run a stretch on the stock caps and run some big spacers.
Yeah I looked into that recently and asked my grandfather who tooked it in to have it done, not even close lol but still a little past stock...I bought a rare set of deep dish lorinsers today, they are 16X8.5 and ill post some later when I test fit them but I am going to get them powdercoated and run a pretty heavy stretch.
Picked up a 93 190e and had plans of lowering it so I did..the ghetto way. But IVe got some e36 coils coming this week and I should have my camber plates shimmed and ready by then. Typical teen build. exhaust, lowered, full respray, euro lights all around and just little interior bits more to come
Leave a comment: