If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It was supposed to be just one diode stuck into a wiring harness, no cutting, just stick it in and go... but I couldn't get it to stay in place while touching metal... I'll figure it out eventually; the diodes are like 23 cents each, but mucking up a wiring harness is priceless... Thanks though!
Nah, this kid offered to do some paint and body work for me, but he considers himself an amateur. If anything, I'll just be paying someone else a bunch more money to take care of it...
Haha, yeah, it is very cliche '90s which is why I'm taking my time pulling them off. I might get a new trunk before paint, and a new hood wouldn't be a bad idea either...
I would start kicking @ your rocker and rear QP's just to see how bad the rust really is. If it's awful I'd just try the reverse half cut honestly. Otherwise it would be sectioning panels off which a lot more people would feel more comfortable doing I feel.
Wheels should be delivered on Thursday. Still need to order tires and then have them mounted. I want to try and get that all taken care of before the UConn Car Show and DOD8... Hopefully I'll have the 2002 to go in, but just in case, I want this ready to at least drive to the shows in.
Wheels and tires are loaded up to head to Banchwerks in Providence tomorrow. I should have them back in a few days and on the miata a few days after that.
Comment