If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Preload adjusted, looked monster truck so dropped another 30mm. Literally perfect fitment now, any compression is cambered in and clears fine. Just need to weld the arches up inside now (not using the car this week so it shouldn't corrode)
Needed about 30mm, maybe more as I plan to go lower in the future.
Trim trim
Sperky sperks
The work so far. Each side cut about an inch in from the lip edge, similar to tubbing I suppose though I want to keep the standard arches, just rolled a lot! Got my old shell to cut the spare metal out of.
Reason I have done this is to roll the outer lip of the arch rather than the inner, I want as much room as possible.
Had this creaking since I put the R33 wheels on the back, horrible sound. Was filming my gf drive up the road earlier to ask a forum when I noticed this:
Eight of the ten spokes cracked! So lucky that the whole wheel didn't collapse. Glad I'm off work this week, means I haven't been using the car much.
Just ordered the paint to spray these rear wheels, hopefully tomorrow night we can get my arches sorted so that I don't have to run these death trap R33s!
Leave a comment: