If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Bought some more parts. Wilwood manual pedal setup because the booster doesn't clear, shaved valve covers (don't worry I'm going to powdercoat them), AN fittings for breather setup and oil feed/drain, and coil relocator brackets.
Found a set of bbs rc041's on craigslist the price was right and they are forged and 1 of 150 sets I've been told. VRwheels will be making lips and barrels for them, and I will get the centers polished.
It's not actually progress on the build but it is at the same time.
Finally bought a tig, went with the Miller Diversion 180.
Going to run 220 to the garage and pick up some filler rod at the local welding place.
Little update, finished welding my trunk shut and ran my fuel lines. Got a set of kirkey pro street drag seats, going to buy the covers and RJS harnesses soon.
Dual 044 bracket arrived today, very nice quality.
Waiting for some more fittings from summit and then all I need are injectors and ms3 to start it up.
Cut out my spare tire well and cut a nice circle with my trusty harbor freight angle grinder and started to weld it in and ran out of argon. At least now I can machine standoffs for the fuel cell and start to run all the lines.
Leave a comment: