If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Did you have to do any work to the rear fenders? I'm running a 16 x 9 et -12 and the sidewall near the tread rubs at the flat area above the flare.
There is no work to the outside but I rolled as much as possible and then lightly tapped the higher inner part in. You have to be careful because it can put outward dents on the flare.
Comment