If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Not much of an update since we've been real busy with the race car the last few days BUT, I did throw the seat on just to get a feel for how it will look. I do plan on doing a lower seat frame eventually.
Also started mocking up the exhaust hangers and making some measurements for the header. I can't decide if I want to trim the mufflers length down some or not. I have a few days before it goes off to power coat though. Opinions?
That's all for now. I'll get some in depth pictures of how everything is going together tomorrow.
I see what you did there and in true Wildmans fashion I would run a crazy straight pipe, but idk how I feel about that on a small motor that pretty much always runs at redline :/
It's mostly back together now aside from a few parts i'm still waiting on in the mail. Yesterday I started on the wiring. Let me just say, I'M EFFING TERRIBLE AT WIRING THINGS ok? ok...
I found some stuff on the computer to help me.
And it told me to take this plug...
and cut it like this...
So I obliged. Then I took this plug
and turned it into this plug
using some of this crap
Then I stabbed myself in the palm. I thought I was going to die. There was just soooo muuuuch BLLLOOOOOODDDDDD 2800 stitches later and I'm good.
damn sorry to hear about your injury. hopefully the recovery process doesnt take to long. are you gonna do physical therapy or anything?
Once the cast comes off and they remove the pins from my fingers I'll have to do some physical therapy. I'm sure it will be strange being in this wheelchair for the next few months though.
Comment