If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
But would you be able to get on the alignment rack without the people complaining?
I got it aligned today. And this was the hardest part. I was just like, whatevs bro. My frame is barely scraping. Obviously I'm not low enough. hahaha
It only cost me 76 bucks for all 4 wheels. Toe is at 0 and camber is only at like -2.5 all around. After that they lose the toe measurement. idk where to go to get more camber. But I will do it soon. For now it's fine. I'm saving up for a bike, and I need this to be a reliable daily. So sorta fitted almost low is good enough for me. Better than what it started out as!
If you lower it after the alignment, the alignment will be out a little. I wouldn't worry about it though since you won't be going more than about 1/2" more down (I assume). Alignment will be super close.
If you lower it after the alignment, the alignment will be out a little. I wouldn't worry about it though since you won't be going more than about 1/2" more down (I assume). Alignment will be super close.
I finally go rollllin' with them today.
Too high, but I'm getting there, I'm getting an alignment tomorrow. I'm going to go lower, and then have them align it. The drive to the alignment shop is going to be scarryyyy. Will it throw the toe off if I get it aligned and then lower it after?
very nice! Was the lime green color the stock lemon lime color from next level motoring?
Yeah! But I wouldn't recommend it. The paint on the wheels was very very shoddy. The paint chipped from putting the wheels on, and after powder coat the wheels look great! And they didn't chip.
Thanks everyone! It's pretty stressful. Especially because I have very limited funds and I might have to end up getting two, or even three alignments to make it sit pretty.
Leave a comment: