If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Interior shots, but it will be changed later, i've got some e24 seats for the rear, and tartan fabric and leather to cover everything. I've got some e12 kind hidden inside door handles too, but i'm not sure whether installing them or not.
Yepp, i'll put the turbines back, after some paintwork. But i have to make a decision about the tyres, now i have 225/45s, but i'm thinking on 215/40s.
The recipe: Cut down the original spring plate, and after that there is 2 ways. My cheap "JDM" coilover set's inner diameter was 50.7(for the rear it's a perfect fit), and the E28 struts are little bit over 52mm. You cold machine up the tube inner diameter, and down the strut. I made an other choice, i found a perfectly fitting threaded tube, that is what i used. And the most important, you need to weld on a stop to the strut for the threaded tube.
I want more low in the front, so i'll put that stop below about 2 cms.
Comment