If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Good day some what. Got the coils in and the new new radiator as the new one blew on me. The seats were an issue so having custom brackets fab'd up to work. Tomorrow is fenders. Than lights, rear etc
And yeah I got these 15x9 et0 4" lips for the track. Cheap and don't give a fuck that there 002's and more prone in the Miata community than freckles on Ginger kids. Sitting on a 195/50. Friday is going to be a good day, coils in than Saturday fenders getting pulled and rolled.
So here's the header. It's wrapped up probably going to re do it and clean them up a bit before installing. Still need an exhaust and cat.
Also you can see the open beam headlights and some JDM yellow goodness for shits and giggles.
Hopefully the euro rear ships out from the UK today.
Gotta get this stuff out of the room and into the car already lol. Ordered wheels nothing special but 4" lips all around and just what I need for drifting. Also ordered Iconcept tie rods and spacers for some
More angle
So after tearing apart the nice interior I come to find these nice rusted panels. Pretty normal to have a tetanus mobile I guess after 17 years. Fuel tank cover was the worst
So pulled off the panels and wire wheeled the rust off and cleaned them up.
Used some good ole fashion JB weld to fill the large gaps in the fuel tank panel. Than primed the pieces and have yet to finish them off in a glossy red.
Inside the car without panels. Lots of shit had to be cut and re shaped to get the actual bar to sit flush.
The roll bar is finally in and will take pics when off work at 2am.
Leave a comment: