If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Not feeling the camber on that, Maybe space the wheels out abit.
defintely agree. I wont be spacing until I've sourced a good set of wheels.
Went through Enkeis, OZs and Konigs yesterday and none I liked! Theyre all on ebay now lol.
Hopefully will get some Works splits or something along those lines. Then I'll space if offset aint good enough
Clean it, ditch the stickers and lights, and please get rid of that camber and raise it slightly til you get some suiting wheels , does look a bit silly at the minute. But after that could look awesome. What pcd are these?
Clean it, ditch the stickers and lights, and please get rid of that camber and raise it slightly til you get some suiting wheels , does look a bit silly at the minute. But after that could look awesome. What pcd are these?
5x114 mate
Since that photo it was slightly raised to get rid of reverse rake and then tracked too.
Like I said, any ideas of wheels, any cost, post them up in my build thread.
Comment