Tweet
Newly registered member checking in for a first introduction...
Well, I guess I can't delete this test post, so I'll just roll with it. Tried uploading a picture of the car, but as you can tell, I'm new and don't know how to properly attach a picture yet.
Anyways... I have a 2014 Hyundai Genesis Coupe 2.0t R-Spec. The username comes from my Instagram @StancedMisiano (I suggest just looking at that for pictures of the GC until I figure out how to properly attach pictures. lol) Bought the car new April 25 2014, started really modifying it around August 2014. Started getting into stance after going down to H2Oi, before that I can honestly say I wasn't much of a camber/stance/slammed person. After that I knew I wanted bags, so started looking into it over the winter. Started to really learning about tire stretch, camber, fitment, stance in general, etc around March 2015 when I picked up my current K3 Projekt wheels and realized the specs were way more aggressive than previously thought. Since then it's been an ongoing education since this is my very first car I've ever modified. I've learned a lot in the past few months, I've been looking on this forum lately for some more info, as well as going through the wheel classifieds looking for my next set of wheels, so I figured it was time to finally register.
Thanks for reading,
Stan
Well, I guess I can't delete this test post, so I'll just roll with it. Tried uploading a picture of the car, but as you can tell, I'm new and don't know how to properly attach a picture yet.
Anyways... I have a 2014 Hyundai Genesis Coupe 2.0t R-Spec. The username comes from my Instagram @StancedMisiano (I suggest just looking at that for pictures of the GC until I figure out how to properly attach pictures. lol) Bought the car new April 25 2014, started really modifying it around August 2014. Started getting into stance after going down to H2Oi, before that I can honestly say I wasn't much of a camber/stance/slammed person. After that I knew I wanted bags, so started looking into it over the winter. Started to really learning about tire stretch, camber, fitment, stance in general, etc around March 2015 when I picked up my current K3 Projekt wheels and realized the specs were way more aggressive than previously thought. Since then it's been an ongoing education since this is my very first car I've ever modified. I've learned a lot in the past few months, I've been looking on this forum lately for some more info, as well as going through the wheel classifieds looking for my next set of wheels, so I figured it was time to finally register.
Thanks for reading,
Stan
Comment