Noob + Weak Fitment = ?

[b.rock]

Never actually properly introduced myself, but I've been lurking for a couple years now. Picked up my first (ever) set of wheels from MemoryFab a couple months ago. They went from this:



To this:



And now they look like this:




Not entirely happy with the fitment, but I'm having a hard time figuring out how to change the specs. Definitely going to run some spacers up front, not sure about the rear. Currently only on springs , camber+coils happening sometime in May. New lips would be ideal as I would prefer more lip than just a wider barrel but I can't seem to find anywhere that makes a non-step lip. Suggestions?

[jasonklee]

Good start. I love WORK Equips.

Welcome to StanceWorks

[On3_Lo35]

Nice wheels, welcome to SW

[cabezzz]

Right wheels, wrong tire size, Welcome to StanceWorks

[hypercrush]

equips are so juicy. im envious. i agree that some downsizing of your tire width would be a big help, and then space it out a bit? but its a matter of what you like i suppose.

[FindingNimo]

nice wheels! welcome! you should reverse stagger.

[kramerbuccs24]

I would say just spacers, a little bit less tire and some camber. I think they'll look great once you dial everything in, great choice in wheels!

[b.rock]

Right wheels, wrong tire size, Welcome to StanceWorks

equips are so juicy. im envious. i agree that some downsizing of your tire width would be a big help, and then space it out a bit? but its a matter of what you like i suppose.

haha no, i completely agree with you guys. i just went with the 45s to fill in some wheel gap until i go lower in a couple weeks here. if i end up getting some new barrels i'll prolly step down to a lower profile and a tire with a little less shoulder. 205/45/17 federal 595s + 8.5" = zero stretch

[b.rock]

I would say just spacers, a little bit less tire and some camber. I think they'll look great once you dial everything in, great choice in wheels!

haha thanks, yeah i'm not sure what spacers i'll run, most likely 15mm front and back. although i've already managed to get a chip in one of the centercaps; i had no idea powerdcoat was so weak.

reverse stagger was my intended setup, but i'm already rubbing up front w/ the wider wheels in the back

[hinrichs]

good start so far, did you try work direct for the lips?

welcome to StanceWorks

[.:Heather:.]

welcome to sw

[b.rock]

good start so far, did you try work direct for the lips?

welcome to StanceWorks

yeah i called work usa - just my luck, they can get lips but only for 18" and up, not for 17"s. FML.

[JawDropper]

Whats wrong with step lips. in my opinion step lips > regular.

[wheelfetish]

Love the wheels!

[JoćoOliveira]

Welcome to SW! Work Equips FTW!