noob, ohio, 645Ci

[Sex45Ci]

New guy from Canton, Ohio.

Didn't really know about the "stance" scene up until a couple months ago. I was mostly into Mustangs But now I have a 2004 BMW 645Ci that I'm look to slam and flush. Stuck on the offset issue. I don't really know what mine is or what offset I will need to poke in the back enough for fender to almost rest in the barrel and be even with the front fender. So if any BMW guys out there have advice it would be greatly appreciated. Thanks.

[ZombieShark]

First of all Beamers are Bikes. The cars are called Bimmers!! Good luck, the car looks to have potential!

[evilstar]

:hi: and welcome.

What the heck is a bmw doing in ohio? especially a new 6? lol sorry just seems a little out of place. I've driven across (well half way across) the country a few times. and I did not see many non american cars out there.

Anyhow good to see another sixer looking stance on here. Wish I could help you with the ET but mine is a few years older. dont think they are the same anymore.

[hinrichs]

welcome to StanceWorks

[P78]

dissapoint it's a new 6

lol

but still

Welcome to S|W

[Zack01GC]

Welcome. I've never seen one of these done up right. The stock offset will be stamped on the wheel someplace, so that can give you an idea as a starting point. Then you can start measuring, and figuriung out where you want the wheel to be, and figure out the offset you want your new wheels to be (or how thick of a spacer you want to run, I'm hoping the previous).

Canton isn't too far from Pittsburgh, if I'm not mistaken?

[JJ.]

Love to see that slammed, I've never seen that type of BMW before got slammed so get to work

Welcome

[jasonklee]

Nice.

Welcome to StanceWorks

[Sex45Ci]

Welcome. I've never seen one of these done up right. The stock offset will be stamped on the wheel someplace, so that can give you an idea as a starting point. Then you can start measuring, and figuriung out where you want the wheel to be, and figure out the offset you want your new wheels to be (or how thick of a spacer you want to run, I'm hoping the previous).

Canton isn't too far from Pittsburgh, if I'm not mistaken?

I know I haven't either. And yeah it's only about 2 hours away.

[Sex45Ci]

Love to see that slammed, I've never seen that type of BMW before got slammed so get to work

Welcome

Thanks =] I'm trying haha

[kbuss]

What the heck is a bmw doing in ohio? especially a new 6? lol sorry just seems a little out of place. I've driven across (well half way across) the country a few times. and I did not see many non american cars out there.

WTF!? Are there only BMW dealerships in California and Florida? I'm pretty sure they are everywhere, this has to be one of the weirdest comments I have read.

[evilstar]

WTF!? Are there only BMW dealerships in California and Florida? I'm pretty sure they are everywhere, this has to be one of the weirdest comments I have read.

are you serious??? I had no idea they had them in Florida too.

[evilstar]

JK obviously there are other dealerships out there they are just not common place in middle america. I'd bet they are out numbered 20 to 1.

anyhow great to see another bmw on here even more since its a sixer.

[B8JacksonS4]

Can't wait to see where this goes, so much wheel well so many options.