Hey Guys,
Ok, so i have asked this question on jdmst but it seems they are only good at buying wheels, not building wheels =/
I have built some Volk GR-C's, the fronts have gone from 16x7+35 to 16x8+38 and the rears from 16x8 to 16x8.5.
From my understanding to get offset of the wheels i measure from inside of lip to the other inside of lip and then halve it, then go inside the wheel where that half is and measure from bolt face to achieve offset.
now i have done that with the front and got same offset as before rebuild, but the rears i got a MASSIVE positive offset and im stressing because it's going to require a fair chunk of spacer to pull a decent fitment.
Have i done this right?
Ok, so i have asked this question on jdmst but it seems they are only good at buying wheels, not building wheels =/
I have built some Volk GR-C's, the fronts have gone from 16x7+35 to 16x8+38 and the rears from 16x8 to 16x8.5.
From my understanding to get offset of the wheels i measure from inside of lip to the other inside of lip and then halve it, then go inside the wheel where that half is and measure from bolt face to achieve offset.
now i have done that with the front and got same offset as before rebuild, but the rears i got a MASSIVE positive offset and im stressing because it's going to require a fair chunk of spacer to pull a decent fitment.
Have i done this right?
Comment