Announcement

Collapse
No announcement yet.

OZ, MSW, ABT, Carlsson, etc 10 point bolt tools review/information.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • OZ, MSW, ABT, Carlsson, etc 10 point bolt tools review/information.

    Roughly 2 months ago I picked up a set of OZ Vegas.
    Like most 3 piece OZ wheels, they are held together with 10 point fasteners.
    The bolt head is 8mm and the nut is 10mm.

    I needed the two 10 point sockets to disassemble them, so I bought a set of Laser brand sockets. 1/2" drive, deep socket. They are the same ones you can find on Amazon, eBay and other sites.
    They look like this:



    The 8mm socket fit fine, but the 10mm one was undersized. I had to hammer it on the nut.
    This is what the nut looked like after:


    I stopped at that point and looked for a single 10mm replacement socket.

    Found out that Snap-On tools now carries both 8mm and 10mm 10 point sockets,
    Part numbers DPTM8 and DPTM10. $15.40 each.





    You can order these through a Snap On dealer, or online. Shipping was free, took about 5 days to arrive.









    High quality sockets, from a reputable company, and they carry a lifetime warranty.
    The 10mm socket is a very good fit. Snap-On on the left


    The 8mm is slightly loose, but not enough to round off or slip. I measured and the OZ bolt heads are not quite 8mm.

    Finished wheels:


    OZ, MSW, ABT, Carlsson, etc 10 point bolt tools info

  • #2
    Good info there.

    Comment


    • #3
      Good to know!

      Just bought a 10mm socket from snap on. I already has the "ebay" ones coming in 8 ad 10mm.

      rebuilding my oz futures soon!!!

      Comment

      Working...
      X