Results 1 to 4 of 4

Thread: OZ, MSW, ABT, Carlsson, etc 10 point bolt tools review/information.

  1. #1
    Join Date
    Mar 2012
    Dallas, Tx

    Default OZ, MSW, ABT, Carlsson, etc 10 point bolt tools review/information.

    Roughly 2 months ago I picked up a set of OZ Vegas.
    Like most 3 piece OZ wheels, they are held together with 10 point fasteners.
    The bolt head is 8mm and the nut is 10mm.

    I needed the two 10 point sockets to disassemble them, so I bought a set of Laser brand sockets. 1/2" drive, deep socket. They are the same ones you can find on Amazon, eBay and other sites.
    They look like this:

    The 8mm socket fit fine, but the 10mm one was undersized. I had to hammer it on the nut.
    This is what the nut looked like after:

    I stopped at that point and looked for a single 10mm replacement socket.

    Found out that Snap-On tools now carries both 8mm and 10mm 10 point sockets,
    Part numbers DPTM8 and DPTM10. $15.40 each.

    You can order these through a Snap On dealer, or online. Shipping was free, took about 5 days to arrive.

    High quality sockets, from a reputable company, and they carry a lifetime warranty.
    The 10mm socket is a very good fit. Snap-On on the left

    The 8mm is slightly loose, but not enough to round off or slip. I measured and the OZ bolt heads are not quite 8mm.

    Finished wheels:

  2. #2
    Join Date
    May 2014
    Columbia, SC


    Good info there.

  3. #3
    Join Date
    Sep 2009


    Good to know!

    Just bought a 10mm socket from snap on. I already has the "ebay" ones coming in 8 ad 10mm.

    rebuilding my oz futures soon!!!

  4. #4


    As opportunities increase competition also increases day by day.The quality of products depend on usage and affordability of people. The reasons of this gathering and also an actual way to handle this content moderation issue.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts