Going to throw this one out there, though I doubt there's much info on it-
Due to the unfortunate combination of gobs of torque requiring fat 315s, IRS subframe clearance, and my quarterpanels, it looks like I'll need to pull my quarters to get adequate clearance.
Has anyone pulled the quarters on a new edge, or even fox body chassis? With the existing seam it looks like it would be quite the challenge. It sounds like pulling is just the same as rolling, just continuing until the fender itself deforms. I'm also not sure which of the usual techniques might be particularly useful, i.e. using a phone book, baseball bat, or regular fender roller.
Any help is appreciated.
Due to the unfortunate combination of gobs of torque requiring fat 315s, IRS subframe clearance, and my quarterpanels, it looks like I'll need to pull my quarters to get adequate clearance.
Has anyone pulled the quarters on a new edge, or even fox body chassis? With the existing seam it looks like it would be quite the challenge. It sounds like pulling is just the same as rolling, just continuing until the fender itself deforms. I'm also not sure which of the usual techniques might be particularly useful, i.e. using a phone book, baseball bat, or regular fender roller.
Any help is appreciated.