Tweet
Had to set of pretty rocked 2 piece 17" bugattis that I had the centers refinished in copper. these rest of the wheel I am unsure of where they walked off to, so this is just for the centers and hardware.
These use the splined studs and are face mount. I originally had the lips machined off the 17" barrels, but then was going to run them as 16s as its easier to just use bbs barrels and lips in that size. No center caps are included but they're readily available. The studs themselves could probably use a refinish, they have some shitty paint on them and a bit of corrosion as they're chrome.
The copper plate is very nice on these, however there are a couple of spots that are buffed through around the lug holes when they were done. Not something you really notice but want to make sure I'm 100% in describing these. I had these done 2 years ago and they've been on the shelf since. Will need a bit of cleaning but beyond that they're ready to go.
Some pics:
$1075 shipped in the us for these.
These use the splined studs and are face mount. I originally had the lips machined off the 17" barrels, but then was going to run them as 16s as its easier to just use bbs barrels and lips in that size. No center caps are included but they're readily available. The studs themselves could probably use a refinish, they have some shitty paint on them and a bit of corrosion as they're chrome.
The copper plate is very nice on these, however there are a couple of spots that are buffed through around the lug holes when they were done. Not something you really notice but want to make sure I'm 100% in describing these. I had these done 2 years ago and they've been on the shelf since. Will need a bit of cleaning but beyond that they're ready to go.
Some pics:
$1075 shipped in the us for these.