FS OZ fittipaldi fittistars... BIG LIPS

[Tropicana]

You lose 12.7mm of offset for every 1" wider lip you add.

Figure it out

your a day late and dollar short.

+.5 = 6.35mm

37mm - 6.35mm
=30.65mm
so round up and that brind its it to et 31.

as it updated 3 posted above you and on the original post.

[KarlSpackler]

You lose 12.7mm of offset for every 1" wider lip you add.

Figure it out

[Tropicana]

What size lip was on there on the beginning when it was ET37?

2.5"

[flossz]

bump for Dave, these wheels will be alot more user friendly with the 3" lip.

[Han]

rear offset is et 32 after the new 3 inch lip

What size lip was on there on the beginning when it was ET37?

[Tropicana]

rear offset is et 31 after the new 3 inch lip

[Tropicana]

i got to measure the barrel again, that doesnt seem right... they were definitely 11" inner lip to inner lip with the 4.5 lips

[Han]

there going to be sold now with 3" lips... yes they are sandwich mounted

3" lip + .5" face + 7.5" Barrel = 11" now.

[Tropicana]

there going to be sold now with 3" lips... yes they are sandwich mounted

[Han]

inner bead to inner bead was 11... if my math is right it should be 9.5 now

With the 4.5" lips? Aren't these wheels sandwich mounted? If so, that has a 1/2" face in between the parts...

What do you mean by 9.5? Width? Offset?

[Tropicana]

inner bead to inner bead was 11... if my math is right it should be 9.5 now

[Han]

the face says et37.. i was under the impression the offset stays the same when just a lip is changed, i thought the offset is determined by the center...

it was either 11 or 12 depending on how you measure...

Offset is determinant of the backspacing and center line. Since the centerline moves as you push out the exterior side (lip side), it will lower the overall offset.

To measure wheels' widths properly, it is measured by the inner bead to the inner bead.

http://www.stanceworks.com/forums/showthread.php?t=3145

[Tropicana]

the face says et37.. i was under the impression the offset stays the same when just a lip is changed, i thought the offset is determined by the center...

it was either 11 or 12 depending on how you measure...

[Ollie]

Are these offsets before or after the lips? 4.5" rear lips with a final ET37 would have to had been 60+ ET rear before.

Also, you said they're 7.5" barrels rear? 7.5 + 4.5 = 12", not 11" and that's if they are face mount/reverse face mount.

+1 doesnt make sense...

[Han]

Are these offsets before or after the lips? 4.5" rear lips with a final ET37 would have to had been 60+ ET rear before.

Also, you said they're 7.5" barrels rear? 7.5 + 4.5 = 12", not 11" and that's if they are face mount/reverse face mount.