Tweet
I have an opportumity to pick up a very nice set of 18x11 squared wheels. The offset is +20. I assume I can make the rear Work (or can I) but what about the front? Is this going to require pulling the fenders and possible further massage?
I have a 2000 Mercedes E320. Its not stanced, but is being lowered with Eibach springs on #1 (5mm) pads.
Any experience or calculations I can use to determine if this is feasible?
I have a 2000 Mercedes E320. Its not stanced, but is being lowered with Eibach springs on #1 (5mm) pads.
Any experience or calculations I can use to determine if this is feasible?
