If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
You should do what I did to my miata and raise the engine. I just used two washers on each of the mounts on the subframe. It raised it enough that it sat just a tad higher than the cross member in front. I could bottom out pretty often and no issues
ive been planning to do that for a while now, just havent had time nor the motivation (too lazy haha)
You should do what I did to my miata and raise the engine. I just used two washers on each of the mounts on the subframe. It raised it enough that it sat just a tad higher than the cross member in front. I could bottom out pretty often and no issues
Leave a comment: