Well I just had my alignment done, and i'm a little confused on what the correct toe settings to get were.
I had always seen everyone on here running 0 toe, so that's what I requested and that's what I got. However, the mechanics there recommended I get 1/4" toe in because they said it would reduce my inner tire wear since I have so much camber (-4 rear, -2.5 front). Iv'e had some bad experiences with mechanics in the past though, and decided to go against them.
Obviously I don't know much about this- so i'm wondering, did I make the right decision or should I have gotten 1/4" toe in? I may go back in the future if my tires are wearing too badly.
Thanks
I had always seen everyone on here running 0 toe, so that's what I requested and that's what I got. However, the mechanics there recommended I get 1/4" toe in because they said it would reduce my inner tire wear since I have so much camber (-4 rear, -2.5 front). Iv'e had some bad experiences with mechanics in the past though, and decided to go against them.
Obviously I don't know much about this- so i'm wondering, did I make the right decision or should I have gotten 1/4" toe in? I may go back in the future if my tires are wearing too badly.
Thanks
Comment