PDA

View Full Version : Manifold Voltage/Amperage



MikeyRa
02-21-2013, 06:14 AM
I built my controller and harness for my Air Lift manifolds and I have been searching online but haven't been able to find much on power requirements. I am going to go ahead and assume it's a 12v system but what should my amperage be at? Just want to make sure so I can have right wire and fuse sizes.

Alex@BagRiders
03-01-2013, 02:54 PM
I'm not sure on the exact amperage of those manifolds but you can run a 10a to 15a fuse on the power to your switches. As for the wiring, 18 to 16 gauge would be fine.

MikeyRa
03-01-2013, 07:31 PM
Thanks for the help Rali, and all the support/parts in thru out my build, although I doubt you realize it lol