So I blew a rocker arm this week and my rocker shaft is gnarred to shit from trying to pull it out and replace a rocker previously. I've decided it's time to remove the head, and replace the shaft. I know I have to get new head bolts and I want to make sure I have the right torque specs. IIRC its 30nm, then two stages of 90° angle torques.
Also does anyone know the pattern they need to be tightened down in? And is there anything else that I should do while I'm in there?
Posted from my magic fingers.
Also does anyone know the pattern they need to be tightened down in? And is there anything else that I should do while I'm in there?
Posted from my magic fingers.
Comment