Hey guys
I currently have some Hamann Motorsport PG's 18x9 and 18x10 on my E39
I'm running a 235/40-18 in the front and a 265/35-18 in the rear(Michilen PS2's). They roll nicley and fit well. They do rub here and there. The rear fenders are rolled and flared(very little). But they lip on the fender is still thick, which stops me from putting any spacers.
I would like to basically have the rim flange aligned with the fender. Should I grind down the fender lip or flare the hell out them? I can roll the front lip on my fenders for a but more clearnace.
Here is how it looks as of today.
Front wheel
Rear wheel
Best suggestions on how to get these fitting on spot?
What tire sizes should I run to space them out a bit and go lower?
Thanks guys!
I currently have some Hamann Motorsport PG's 18x9 and 18x10 on my E39
I'm running a 235/40-18 in the front and a 265/35-18 in the rear(Michilen PS2's). They roll nicley and fit well. They do rub here and there. The rear fenders are rolled and flared(very little). But they lip on the fender is still thick, which stops me from putting any spacers.
I would like to basically have the rim flange aligned with the fender. Should I grind down the fender lip or flare the hell out them? I can roll the front lip on my fenders for a but more clearnace.
Here is how it looks as of today.
Front wheel
Rear wheel
Best suggestions on how to get these fitting on spot?
What tire sizes should I run to space them out a bit and go lower?
Thanks guys!
Comment