Hey guys, just posting for ideas on how I should do this...I have a mk1 Audi TT that I'm installing air ride on and I'm trying to figure out my controller placement. I picked up a used autopilot V1 setup, but there is next to no room in the car to place the controller.
This is what I have to work with...pathetic lol
After deliberation, I decided to try to mount it in place of the ash tray. Unfortunately, however, the controller will stick down farther than the console area, so I'll have to make it look as best I can.
I'm thinking of molding it in like this.
What do you recommend I use to do this? A very thick piece of plastic and then cut to fit and mold the controller in? That's the only thing I can think of at this point...TIA for ideas and help
This is what I have to work with...pathetic lol
After deliberation, I decided to try to mount it in place of the ash tray. Unfortunately, however, the controller will stick down farther than the console area, so I'll have to make it look as best I can.
I'm thinking of molding it in like this.
What do you recommend I use to do this? A very thick piece of plastic and then cut to fit and mold the controller in? That's the only thing I can think of at this point...TIA for ideas and help
Comment