Calling on Mike for e24 offsets

[Russell_G]

Mike, Time for wheels on the e24 and i wanted to know what you know....Poke yes but just the lip of the wheel Stretch is a yes too and i will be pulling the bottom bodyline on the fender to fit the stretch.

What ya think? Know of any wheels FS?

Gotta get pics of my Dad in this car when finished. Its for his 50th bday

[M.Burroughs]

Up front, 9.5" wide, -10 offset, sat like this:




10.5" wide out back, et-5 out back would be what I would go with.

That's with stock fenders though.
You could EASILY fit 10s and 12s front and rear, at pretty much 0 offset on both with some massaging out back.

[4eyes]

goddamn, why did you sell your six? so hot.

[riffman12]

seriously Mike

son I am disapoint

[Russell_G]

found this looking around online...kinda cool cause i have only seen one 6er low with a bit of camber

[Zack01GC]

That's EtownC's car, he's on this site.

If I remember correctly his wheels are 16x9.5 ET0 all around.

Russell... there is another 6er that comes to mind concerning low and camber... In case you haven't seen it yet. M.Burrough's old car.

[frey328is]

Russell... there is another 6er that comes to mind concerning low and camber... In case you haven't seen it yet. M.Burrough's old car.

haha in case he didnt see it already posted

i <3 that car